Commandline output path
Posted: 17 May 2020, 12:39
Hi,
I try to use the following commandline to convert videos:
This works in principle. In the GUI output path is set to: "The same (near the video)"
When using GUI the output thumbnails are created whereever the input video was located. Fine.
With the commandline the output thumbnails are created in a folder "Internet" in my Video Thumbnails Maker folder. Not fine.
Anything I am doing wrong here?
Thanks for any help or tipp.
Cheers
Klaus
I try to use the following commandline to convert videos:
Code: Select all
VideoThumbnailsMaker.exe kls_movie.vtm video_in.avi
When using GUI the output thumbnails are created whereever the input video was located. Fine.
With the commandline the output thumbnails are created in a folder "Internet" in my Video Thumbnails Maker folder. Not fine.
Anything I am doing wrong here?
Thanks for any help or tipp.
Cheers
Klaus