Page 1 of 1

Can't handle filenames with # vs #

Posted: 01 Jun 2018, 09:45
by choyj
It took me a while to notice this, but I get the following error when I have # in the filename, which is different than #.

Code: Select all

[DEBUG] [11:38:25 PM] .... Ultimate engine failed , making an attempt to use Secondary engine
[DEBUG] [11:38:25 PM] .... Engine 1: Can't render the file
Yes, the characters look the same, but copy the first # and put it in a filename. Or better yet, copy this whole message and put it in wordpad and you'll see the # and # are a little bit different.

Re: Can't handle filenames with # vs #

Posted: 01 Jun 2018, 21:00
by admin
I will check that.
Thank you.

Re: Can't handle filenames with # vs #

Posted: 01 Jun 2018, 21:10
by admin
Indeed, Ultimate engine fails.

As temporary solution, you can select Crystal as the Secondary egnine - it will handle such files.

Re: Can't handle filenames with # vs #

Posted: 03 Jun 2018, 04:19
by choyj
The other temporary solution is to just rename the file with the proper '#' and all is well.